PrintDry Filament Dryer PRO3
For quality 3D printing
- Easily adjust the temperature with 6 presets (35ºC, 45ºC, 55ºC, 65ºC, 75ºC, and 85ºC).
- Built-in timer with a maximum time of 48 hours.
Note: The temperature readings are directly measured at the tip of the temperature sensor, located about 15 mm away from the hot air vent. The temperature distribution inside the dryer is not uniform. The temperature in a place close to the hot air vent is higher and the temperature in a place far away from the hot air vent is lower.
Outside dimensions: 340mm (L) x 285mm (W) x 350mm (H)
Large Spool Kit (double-wall)
For PrintDry Filament Dryer PRO/PRO3
- Double-wall chamber
- Used with the PrintDry Filament Dryer PRO/PRO3.
- To dry and feed up to 5Kg filament spool with max 300mm or 12” spool outside diameter.
With a large spool kit, the dryer can be used to dry and feed up to 5Kg filament spool with max 300mm or 12” spool outside diameter.
Note: When drying and printing a new 12″ filament spool, please set the temperature 10C lower to start with. After about 25% filament has been printed, then the temperature can be reset to the normal recommended temperature for this filament. This will avoid filament over-heating.
Package includes:
- Plastic tray x1
- Long metal shaft x1
Additional Chamber Kit (double-wall)
For PrintDry Filament Dryer PRO/PRO3
- Double-wall
- Used with the PrintDry Filament Dryer PRO3.
- To dry and feed two more additional spools with max 200mm or 8″ spool outside diameter.
With our additional chamber kit, the dryer can be used for 4 1Kg spools, which means one dryer can serve more printers.
To dry and feed two more additional spools with max 200mm or 8″ spool outside diameter.
Note: Due to the stackable chamber design, you can use multiple additional chamber kits per dryer; however, the temperature and stability decrease as you add more chambers. We don’t recommend using more than two additional chamber kits per dryer.
Package includes:
- Plastic tray x2
- Metal shafts x2
- Support bridge x1
- Big spool adapters x4
- Small spool adapters x4
Spool containers
Package includes:
- 2 x Large filament containers (up to 5kg spool)
- 2 x Regular filament containers (standard 1kg spool)